Electrical Equipments & Supplies

1500W 30A DC-DC 10V-60V to 12V-90V Adjustable Constant Current Boost Converter Non-isolated Step-up Power Module



Module properties: non-isolated step-up module (BOOST)

Input voltage: DC 10V~60V

Input current: 10~30V input voltage, maximum current 30A

31~60V input voltage, maximum current 25A

Quiescent current: 15 mA (12V liter 20V, the output voltage, the higher the current will increase too quiet)

Output voltage: 12~90V continuously adjustable

Constant] range: 0.8~20A(±0.3A)

Temperature: -40~ + 85℃(ambient temperature is too high, please enhance heat dissipation)

Operating frequency: 150 KHz

Conversion efficiency: 92% ~ 97%

Low battery protection: yes

Input reverse polarity protection: yes

Enter the anti-reverse protection: yes

Short circuit protection: yes

Installation: 4 x 3 mm screw holes

Module size(L*W*H): 130 x 52 x 85 mm


1.DIY a power supply, 12V can input and output can 12-50V adjustable.

2.The power supply for your electronic device, according to your system can set the output

3.As the car power supply for your laptop, PDA or a variety of digital products supply.

4.DIY a mobile notebook power supply: 12V coupled with high-capacity lithium battery pack, so you can go where light where books.

5.Solar panel regulator.

6.To the battery, rechargeable lithium batteries.


1.Thickening of the radiator and intelligent temperature control cooling fan.

2.Have input MOS meter protection, don\'t worry about input after burn out the power supply.

3.When used in battery input low battery protection avoid battery discharge damage power supply module and a battery.


Manual measuring, please allow 1 ~ 3 cm error,thank you.


1 x Boost Constant Current Module

  • Coil Number: Power Converter
  • Brand Name: diymore
  • Phase: Power Converter
  • Coil Structure: Power Converter
  • Model Number: 051087
  • Usage: Current

  • Package Weight: 0.01kg (0.02lb.)
  • Unit Type: piece
  • Package Size: 10cm x 10cm x 10cm (3.94in x 3.94in x 3.94in)

  • Author: Toxa Zav2
  • Date: 2018-03-31
  • The inductor / coil / choke is very badly and poorly soldered for the print circuit board.
  • 3/5

  • Author: Werner Niko
  • Date: 2018-04-11
  • muibien ok
  • 5/5